High voltage of transformers

I'm looking for a possible simple circuit as I cannot control to a transformer that I can use it as a source of high voltage. The circuit with the E is already quite great shocker but you need 2 windings. There is a circuit where I can make something out of 1 Prim Wicklumg? Get the ignition coil Zer hacker circuit from the MK side which should be quite well funzen. have I tried with nem mormalen Printtrafo! But not much is here! I think a small transformer from a disposable camera would be better suited. You need in any case any switching element so a normal bipolar transistor or a HV electrical .
 
This is the most important thing is to Netzteiltopologien to see it in principle. Voltage-guided operating mode, it is possible that the primary current is running or that just the core saturates. Up to half - / Vollbrückentopologien a Lück end power curve is used, however, the power-run push-pull converters can exploit the full hysteresis loop of the core. You can implement Flyback and forward converters as one transistor circuits, and both need no further taps. Sure they work but also not resonant and significant switching losses occur at larger scales of power.

The rectifier secondary only consists of a simple diode, a bridge driver has some advantages over the other topologies, especially services targeted by you.

I can advertise for Flybackwandler HV MOSFETs with good suppressor from personal experience.